--- title: Controller Functions slug: gpc/gpc-scripting-controller-functions description: Here is the list of Controller Functions. icon: ◼️ docTags: createdAt: 2021-12-04T12:30:38.000Z --- A controller is an input device, however, the Cronus Zen also sends data to control the rumble motors and LEDs. | Function Name | Description | | ------------------ | ------------------------------------------------------------------------------------------------------------------------------------------- | | get\_val | Returns the current value of a controller entry. | | get\_lval | Returns the previous value of a controller entry. | | get\_ptime | Returns the elapsed time of a controller entries state change. | | get\_controller | Returns the type of controller currently connected to the input port. | | get\_battery | Returns the current status of the battery for a wireless controller. | | event\_press | Returns TRUE when a controller entry has been pressed. | | event\_release | Returns TRUE when a controller entry has been released. | | get\_ival | Gets the input value of a button. | | get\_brtime | Gets the time the input value has been 0. | | swap | Swaps the input values to be sent to the console temporarily. | | block | locks the input from being sent to the console for the specified time. | | sensitivity | Changes the input sensitivity. | | deadzone | Modifies the inner "deadzone", and essentially pushes the starting value (when not 0) from the center by deadzone\_x/deadzone\_y or radius. | | stickize | Modifies outer deadzone, essentially forces the stick to not be further out than the radius from the inner point. | | ps4\_touchpad | Returns detailed information on the DualShock 4 touchpad state. | | ps4\_set\_touchpad | Touches the DualShock 4 touchpad in a specific (X, Y) position. | | turn\_off | Turns off a wireless controller connected to the input port. | | wiir\_offscreen | Checks if the Wii remote is off-screen. | Controller functions for Core Controller Functions can be found here: [Core Controller Functions](docId:05culJGgGOcUK_dDW4sNU) # Rumble Functions | Function Name | Description | | ------------- | ------------------------------------------------------------------------------- | | get\_rumble | Returns the current value of a Rumble Motor. | | set\_rumble | Sets the speed of a Rumble Motor. | | block\_rumble | Blocks any rumble signals from the console. | | reset\_rumble | Resets the rumble state and returns the condition of the motors to the console. | Controller functions for Rumble Functions can be found here: [Rumble Functions](docId\:L5u2t8f0L35BlB1y3LP6R) # LED Functions | Function Name | Description | | ------------- | ------------------------------------------ | | set\_led | sets the state of the LED on a controller. | Controller functions for LED Functions can be found here: [LED Functions](docId\:z1QvPHAsU6qdl9VFxOw4V)